- Hello sorry not updated for so long. Had problems with camera...all fixed now, Bellow are some Mazda seats that i re trimmed the centre seat panels for a customer . I hope you like what you see
- you can contact me on :
- email : incavilla@aol.com
- tel : 07794978914
As you can see above the drivers seat had most wear but surprisingly the side panels were in good condition, So removal of the centre for trimming was all that was needed.
With a few swear words.....the complete seat was removed ,they did not make it easy to get at the fixings.
A close up view of the worn area. The customer supplied the replacement cloth needed.
All here A few repairs were needed to the foam seat swab, once glued they were strengthened with calico patches.
This shows the removal of the fixing clips........oops sorry about the wrong sequence of pics, great care is needed at this stage as not to damage the foam and fixing rods.
This shows the new foam backed material being glued to a backing cloth to give it more strength allowing the fabric to be sewed.
There all cut and ready to sew, TIP : always make sure the brush ( nape of the material ) is cut in the same direction as this is easy over looked.
The magic tools, the are called hog ring pliers a must need tool for this job.
There all done and back round the foam swab ready to fit to the frame work.
There you go .......looking as good as new.......sorry about the water marks on the picture .
Both seats done and ready for the customer to pick up, I hope you liked what you see, keep looking as got loads more to put on hear soon.
Colin
